1. The use of double roller brush for cleaning work not only speeds 3-10km/h, but also has high cleaning efficiency and better cleaning effect. The work speed and range of its design are relatively wide, and the driver can well grasp the speed of the operation according to the required degree of contamination of the clean surface. 2. In the cleaning work of the guardrail cleaning vehicle , the height adjustment of the cleaning brush and the position of the guardrail base should be equal, so that when the guardrail is performed, the guardrail bottom seat can also be cleaned together, allowing one-time cleaning. Cleaner work. 3. In order to increase and improve the cleanliness of the cleaning work of the guardrail cleaning vehicle, the design method that does not require the addition of the cleaning solution is used in the Warwick Austrian guardrail cleaning vehicle. No matter what kind of cleaning solution is more sticky, it is After the water is mixed, it is ejected, and at the moment it is ejected, it cannot be vaporized. Therefore, this will reduce the friction between the brush filaments and the cleaning surface, thereby reducing the cleaning effect. The brush filaments of the cleaning brush they designed use multi-sided polyethylene super soft materials to design, not only will not damage The antisepsis decoration layer and the surface of the steel plate can also effectively clean different dirt, and it is more environmentally friendly than the cleaning method of adding the cleaning liquid. 4. The cleaning brush of the fence cleaning car has a special brush design. When the fence is clean, it will not be painted or leave a clean corner. It uses a double brush head and a cylindrical design that can perform two brushings at the same time and three to five sprays. Cleaning can be directly based on the scientific design of the brush body's centrifugal force generated by brush filaments. Too long brush filaments will reduce the centrifugal stress and cleaning effect of brush filaments. The length of the brush body can be designed based on the width of the standard steel plate. In the work, the distance between the surface of the steel plate and the brush body is 25 CM. The long brush body may cause unnecessary waste due to the different degree of local wear. Multi-edge flexible brush filaments are brushed with high pressure and do not damage the paint surface. The constant distance between the hydraulic protection device and the guardrail and the maintenance of the roller brush can make the cleaning quality more stable. (Text / Sun Ni) Zhejiang Shengfa Textiles Printing&Dyeing.,ltd , https://www.chzjsf.com
