Corrosion-resistant hot oil pump fault repair and maintenance

Corrosion-resistant hot oil pump with the growth of the use of time, there will be inadequate pump oil, pump or even failure, mainly due to excessive wear and tear on the parts. Corrosion-resistant hot oil pump wear parts are the main shaft and bushings, passive gear center hole and shaft pin, pump housing cavity and gear, gear end face and pump cover. Lubricating oil pump wear of its main technical indicators fail to meet the requirements, it should disassemble, find out the location and extent of wear and tear, to take appropriate measures to be repaired.

Corrosion-resistant hot oil pump cavity cavity repair: After the pump cavity wear, the general use of lumen inlaid method to repair, is about to enlarging the inner cavity set with cast iron or steel bushings. After setting the sleeve, the cavity enamel to the required size, and wear out the end face of the liner to flush with the pump housing surface.

Corrosion-resistant hot oil pump drive shaft and bush wear, with the gap increases, will certainly affect the pump oil. In this case, you can repair the drive shaft or bushing method to restore its normal with the gap. If the drive shaft wear slightly, simply press the old bushing and put on the standard size bushing, with the gap can be restored to the allowable range. If the drive shaft and bushing wear serious and serious with excessive clearance, not only to replace the bushing, and the drive shaft also applies chrome or vibration welding method to increase its diameter, and then grinding to the standard size, recovery and bushing With the requirements. Repair of the oil pump housing Repair of the crack in the housing: Crack of the housing can be cast 508 nickel-copper welding electrode. Welds to be close and yuan stomatal, with the flatness of the pump cover with no more than 0.05 mm flatness. Repair of drive shaft bushing hole: The repair of drive shaft bushing hole on pump cover is the same as repair method of wear of drive shaft bushing hole of housing.

Corrosion-resistant hot oil pump work plane repair: If the pump cover wear a small working surface, manual grinding method can be used to eliminate wear marks, that is, put a little valve on the platform or thick glass sand, and then put the pump cover on the grinding, resistance Corrosion Hot pump with the use of time, there will be inadequate pump oil, pump or even failure, mainly due to excessive wear and tear on the parts. Corrosion-resistant hot oil pump wear parts are the main shaft and bushings, passive gear center hole and shaft pin, pump housing cavity and gear, gear end face and pump cover. Lubricating oil pump wear of its main technical indicators fail to meet the requirements, it should disassemble, find out the location and extent of wear and tear, to take appropriate measures to be repaired. Corrosion-resistant hot oil pump work plane repair: If the pump cover wear a small work surface, manual grinding method can be used to eliminate wear marks, that is, put a little valve platform sand or thick glass plate sand, and then the pump cover on the grinding until Wear marks removed, the work surface so smooth. When the pump cover working plane wear depth of more than 0.3 mm, should be taken after the first turning grinding method to repair. Follower shaft wear and tear to wear and tear to eliminate traces of reaming method, and then press the hole reaming the actual size of the preparation of the driven shaft.

Heat Resistant Steel Castings

The heat - resistant steel heat treatment furnace components produced by our company are sold throughout the country. During many years of continuous research and development, our company has developed a number of new materials which further meet with the requirements of heat resistant non-scale and non-deformation. Components can be produced from 0.1kg to 1500kg.